◼ Features
● Drill a hole in the side or bottom of the heating container, insert the heater and install it with the supplied packing, washer and nut.
● The sheath material uses copper pipes with good thermal conductivity and a nickel-plated finish, so it is ideal for water heating.
◼ Types
| U-Tubular Heaters: Side
Configure of standard types
All products listed are available in different voltages.
* Nickel-plated copper pipes are used for the sheaths.
| U-Tubular Heaters: Over-the-Side
Configure of standard types
All products listed are available in different voltages.
* Nickel-plated copper pipes are used for the sheaths.
| Coil Heaters
Configure of standard types
All products listed are available in different voltages.
* Nickel-plated copper pipes are used for the sheath.
| Single-phase Flower-shaped Heaters
Configure of standard types
All products listed are available in different voltages.
* Nickel-plated copper pipes are used for the sheaths.
* The heaters are wired for 200 V before shipment. If you want to use your heater at 100 V, connect the supplied shorting bar (refer to Fig. a.).
| Three-phase Flower-shaped Heaters
Configure of standard types
All products listed are available in different voltages.
* Nickel-plated copper pipes are used for the sheath.
◼ Precautions when using this product
●This product is for industrial use only.
●Do not expose the terminal of the heater to water.
●Do not use the heater at a voltage exceeding the rated voltage.
●Scale (e.g., water scale or oxide) will eventually form on the surface of the heating portion. Periodically inspect and clean the heater.
●Do not expose the heating portion to the air. There is a risk of fire as well as premature wire breakage.
.jpg)
